Pay attention to machine wear during the break in period of small loaders

A small loader is a special type of engineering vehicle, and all personnel driving and operating small loaders should receive formal training and guidance, have a full understanding of the mechanical structure and performance of small loaders, and obtain certain operation and maintenance experience before operating the machine.

1. All small loaders come with the "Hydraulic Loader Safety Operation and Maintenance Manual" provided by the manufacturer at the factory price, which is a necessary information for operators to operate the equipment. Before operating the machine, it is necessary to read the "Hydraulic Loader Safety Operation and Maintenance Manual" and carry out operation and maintenance according to the requirements.

2. Pay attention to the workload during the running in period. During the running in period, half of the workload should not exceed 60% of the rated workload, and appropriate workload should be arranged to prevent overheating caused by prolonged continuous operation of the machine on site.

3. Pay attention to regularly observing the indications of various instruments. If any abnormalities occur, stop the vehicle in a timely manner for troubleshooting. Stop working until the cause is identified and the fault is resolved.

4. Pay attention to regularly checking the level and quality of lubricating oil, hydraulic oil, coolant, brake fluid, and fuel oil (water), and check the sealing of the entire machine. During the inspection, it was found that there was an excessive lack of oil and water, and the cause should be analyzed. At the same time, lubrication at each lubrication point should be strengthened. It is recommended to add lubricating grease to each lubrication point during the running in period (except for special requirements).

5. Keep the machine clean, adjust and tighten loose parts in a timely manner to prevent further wear or loss of parts due to looseness.

At the end of the running in period, the machine should be subjected to mandatory maintenance, inspection and adjustment work should be done well, and attention should be paid to the replacement of oil.

In summary, the maintenance requirements for small loaders during the running in period can be summarized as: strengthening training, reducing load, paying attention to inspection, and enhancing lubrication. As long as the maintenance and upkeep of small loaders during the break in period are taken seriously and implemented according to requirements, the occurrence of early failures will be reduced, the service life will be extended, the operating efficiency will be improved, and the machine will bring you more benefits.